Compaq WL110, User Manual

Page: 131 / 144

Troubleshooting B-5
Figure B-1 Reset Button
3. Use a small pointed object, such as the tip of a ball-point, to press the
Reset
button.
The Access Point will restart and run the start-up diagnostics, characterized
by a LED sequence where the LEDs change color in the range Red, Amber,
Green.
4. When the Power LED is green, and other LEDs are off or flickering
(indicating LAN activity), you can mount the cover of the Access Point.
After approximately 15 seconds, the unit will start bridging operation using the
configuration parameters as they were stored in the Access Point prior to the
reboot.
Remote Reboot
To reboot the Access Point from a remote location:
1. Start the A PManager program.
2. Select the target Access Point from the list or enter the IP address for a
specific Access Point.
3. Open the Access Point menu.
4. Select
Reboot
Access Point.
The AP Manager program will now prompt you to enter the password
required to reboot the device.
5. Enter the Read/Write password and click
OK
.
6. The Access Point will restart and run the start-up diagnostics.
After approximately 15 seconds, the Access Point will start bridging operation
using the configuration parameters as they were stored in the Access Point prior
to the reboot.
If you would like to display the configuration file or monitor the Access Point's
performance after a reboot, you may have to wait until the unit completes the
start-up diagnostics before you can access the Access Point again.