GS320 Assembly
3-7
The system is assembled on site by connecting the two system cabinets and the
power cabinet. Before you start any installation procedure:
1.
Ensure that the site is properly prepared to install the system. Refer to the
AlphaServer GS160/320 Site Preparation
for system specifications and
requirements.
2.
Roll system cabinets off pallets.
3.
Remove all protective packaging.
4.
Ensure that you have the joining kits listed in Table 3–1 for the installation.
The system is installed in four stages:
1.
Prepare system cabinet 1 for installation.
2.
Prepare system cabinet 2 for installation.
3.
Join system cabinet 2 to system cabinet 1.
4.
Join power cabinet to system cabinet 1.
Refer to Chapter 2 if you need to install a dual-AC switch cabinet and/or
expander cabinets.
After you have finished installing the system, hand the shipping brackets to the
customer to keep for later use. Shipping brackets are required for moving the
system.
WARNING:
Before you power up the system, inspect the modules for
any visible sign of water condensation on the heatsinks, DC-to-DC
converters, and the CPUs. Due to the large mass of the GS160/320
system, condensation may occur during transfer from a cold to a warm
environment. Allow time for the condensation to evaporate com-
pletely. DO NOT power the system up if you notice any indication of
condensation.
Summary of Contents for AlphaServer GS160
