GS160 Assembly
2-21
Expander cabinets can be added to either side of the system. To add an
expander cabinet, proceed as follows:
NOTE:
If a dual-AC switch is to be attached to the system, first attach the dual-
AC switch to the power cabinet as discussed in Section 2.5. Then attach
the expander cabinet to the dual-AC switch cabinet or system cabinet 1.
1.
Roll the expander cabinet flush along the side of the power cabinet or
system cabinet leaving a minimum gap between cabinets
.
2.
Align cabinet heights by adjusting the leveling feet
.
3.
Once the expander cabinet is well aligned with the power or system cabinet,
use the four screws and the Allen wrench supplied with the expander
cabinet to secure the cabinets together at all corners
.
4.
Connect the system ground wire from the expander cabinet to the power
cabinet
or system cabinet. For each additional expander cabinet, daisy
chain a system ground wire.
5.
Make host connections (PCI box, storage) and the CSB connection. These
connections are configuration dependent.
This completes the installation of an expander cabinet.
Summary of Contents for AlphaServer GS160
