Page 19 of 41
© 2019 CommScope, Inc. All Rights Reserved
13.2.3 Install strain relief on drop cable
13.2.3.1 Put the metal clip on the cable. Align the sheath opening with the concave slot in the metal clip. Wrap the aramid
yarn around the clip as shown. The aramid yarn should be positioned under the tags of the metal clip.
13.2.3.2 Mount the carrier on the clip-cable assembly. The two tabs of the carrier should be positioned in the two slots of
the metal clip, then turn the carrier towards the cable.
13.2.3.3 Push until the two snap hooks snap in the slots of the metal clip. Pull on the aramid yarn to verify it is properly put
under tension. Cut off the excess aramid yarn.
13.2.3.4 The metal clip can also be installed without using aramid yarn. Installation of the cable follows the same procedure
as steps 13.2.3.1 - 13.2.3.3.
13.2.4 Install drop cable
13.2.4.1 Slide the carrier with the cable secured into the slots of the organizer.
2
1
3
2
1
2
1
2
1
3
2
1
1
Front
