Page 15 of 41
© 2019 CommScope, Inc. All Rights Reserved
12.2
Directly to splice tray rear
12.2.1
Cut the subunits at the jacket end installed on side F2 (endcut) OR cut the subunit in the middle (midcut).
The non-used end can be re-stored in the loop storage.
12.2.2
Bring the cut subunit to the splice tray (rear) and mark the stripping point. Strip the subunit to this mark and clean
all fibers per standard practice.
12.3
Via uncut fiber storage
Note: Maximum 2 subunits can enter the uncut fiber storage.
The uncut fiber storage can be used with shaved subunits or with cut subunits.
12.3.1 Shaved subunit
12.3.1.1
Bring the selected subunit to the rear of the loop storage, the uncut fiber storage.
Note
: It is important that the
selected subunit is routed first and that the bundle of subunits is installed back on top of this routed subunit.
12.3.1.2
Put the selected subunit on top of the uncut fiber storage basket and indicate the marks (stripping points) between
which the subunit should be shaved. Shave and clean the subunit per standard practice. Cut the fiber to be spliced at the
jacket end of the subunit, side F2.
remove
cover
1
stripping
point
stripping
point
subunits
endcut
midcut
+/-1 cm
0.4”
F2
F1
stripping
point
stripping
point
1
F2
F1
endcut
subunits
uncut fiber storage
