1. General
Page 10
M0200AKA_uc_ION-U_EU_L_25T_25T.docx
User’s Manual for ION
®
-U
3. Notice:
Installation of this equipment is in full responsibility of the installer, who has
also the responsibility, that cables and couplers are calculated into the maximum
gain of the antennas, so that this value, which is filed in the FCC Grant and can be
requested from the FCC data base, is not exceeded. The industrial boosters are
shipped only as a naked booster without any installation devices or antennas as it
needs for professional installation.
4. Notice:
For installations which have to comply with
FCC/ISED requirements:
English:
This device complies with FCC Part 15. Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the
device.
This device complies with Health Canada’s Safety Code. The installer of this device
should ensure that RF radiation is not emitted in excess of the Health Canada’s
requirement. Information can be obtained at
http://www.hc-sc.gc.ca/ewh-
semt/pubs/radiation/radio_guide-lignes_direct-eng.php
.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Antenna Stmt for ISED:
This device has been designated to operate with the antennas having a maximum gain of
9 dBi. Antennas having a gain greater than 9 dBi are prohibited for use with this device
without consent by ISED regulators. The required antenna impedance is 50 ohms.
The antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 100 cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter. Users and installers must be provided with antenna
installation instructions and transmitter operating conditions for satisfying RF exposure
compliance.
French:
Cet appareil est conforme à FCC Partie15. Son utilisation est soumise à Les deux
conditions suivantes: (1) cet appareil ne peut pas provoquer d’interférences et (2) cet
appareil doit accepter Toute interférence, y compris les interférences qui peuvent causer
un mauvais fonctionnement du dispositif.
Cet appareil est conforme avec Santé Canada Code de sécurité 6. Le programme
d’installation de cet appareil doit s’assurer que les rayonnements RF n’est pas émis au-
delà de I’exigence de Santé Canada. Les informations peuvent être obtenues:
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-lignes_direct-fra.php
Les changements ou
modifications non expressément approuvés
par la partie
responsable
de la conformité pourraient
annuler l’autorité
de l’utilisateur
à utiliser
cet équipement
.
Antenne Stmt pour ISDE:
Ce dispositif a été désigné pour fonctionner avec les antennes ayant un gain maximal de
9 dBi. Antennes ayant un gain plus grand que 9 dBi sont interdites pour une utilisation
avec cet appareil sans le consentement des organismes de réglementation d’ISDE.
L’impédance d’antenne requise est 50 ohms.
Summary of Contents for ION-U EU L 25T/25T
Page 1: ...ION U ION U EU L 25T 25T User s Manual M0200AKA ...
Page 62: ......