CommScope ION-U EU L 25T/25T, User Manual

Page: 9 / 62

1. General
M0200AKA_uc_ION-U_EU_L_25T_25T.docx User’s Manual for ION
®
-U Page 9
7. Notice: Read and obey all the warning labels attached to the unit. Make sure that
all warning labels are kept in a legible condition. Replace any missing or damaged
labels.
8. Notice: Only license holders for the respective frequency range are allowed to
operate this unit.
9. Notice : Make sure the repeater settings are correct for the intended use (refer to
the manufacturer product information) and regulatory requirements are met. Do not
carry out any modifications or fit any spare parts, which are not sold or
recommended by the manufacturer.
1.4. Compliance
1. Notice : For installations which have to comply with European EN50385 exposure
compliance requirements, the following Power Density limits/guidelines (mW/cm²)
according to ICNIRP are valid:
o
0.2 for frequencies from 10 MHz to 400 MHz
o
F (MHz) / 2000 for frequencies from 400 MHz to 2 GHz
o
1 for frequencies from 2 GHz to 300 GHz
2. Notice: For installations, which have to comply with FCC RF exposure
requirements, the antenna selection and installation must be completed in a way to
ensure compliance with those FCC requirements. Depending on the RF frequency,
rated output power, antenna gain, and the loss between the repeater and antenna,
the minimum distance D to be maintained between the antenna location and human
beings is calculated according to this formula:
] / [
] [
] [
2
4
cm mW
mW
cm
PD
P
D
 


where

P (mW) is the radiated power at the antenna, i.e. the max. rated repeater
output power in addition to the antenna gain minus the loss between the
repeater and the antenna.

PD (mW/cm²) is the allowed Power Density limit acc. to 47 CFR 1.1310 (B) for
general population / uncontrolled exposures which is
o
F (MHz) / 1500 for frequencies from 300MHz to 1500MHz
o
1 for frequencies from 1500MHz to 100,000MHz
RF exposure compliance may need to be addressed at the time of licensing, as
required by the responsible FCC Bureau(s), including antenna co-location
requirements of 1.1307(b)(3).