- 11 -
Installing the out door panel
Connecting the power wires
1. The power wires on the out door panel must be connected the
right polarity from a house (DC 12V).
Door open wires
1. Door open wires can be used to connect with “Door Lock”
Notes:
Door open wires use non-polarities.
The recommended setting location should be 135 Cm from
the ground.
Important Note
The distance(Cover range) between the DECT Base and the Out Door
Panel may vary, depending on the obstacles there are between them
and the interface that may be caused by other devices.
Therefore, the recommendation is that DECT Base should be close
with Out Door Panel.
Operation Out Door panel
1. When push the call button on the Out Door Panel, a call
signal is sent to the DECT Base and beep the ring on Out
Door Panel and hand set.
Notes: The lamp is flashing on the out door panel.
The call time is 30sec.
2. The handset display Call and beep a ring tone.
3. Push
the
TALK
key on the hand set and then can talk with a
guest to be call in out door.
Notes: The lamp is changing Red light.
The talk time is 90sec.
4. If to open the door, press the
“0”
key on the hand set.
5. To
end
talk
, press the “END” key
Important Note
If Out Door Panel call the DECT base during DECT phone is
using(intercom or external calling), a guest hear short beep “TIC TIC”
by the Out Door Panel and can’t connect with DECT phone.
The same time, Handset beeps a short alert beep.
During the DECT Base is power off or Out Door Panel is searching the
DECT Base, the lamp is flashing on the Out Door panel.
Summary of Contents for WDP-180D
Page 1: ......
Page 8: ...8 Wiring and Installation WDR 2GD WDR 2GD supply DC 12V power 1 RED 2 BLUE...
Page 49: ...49...