Command Communications privatetime PT1000, Operator'S Manual

Page: 7 / 28

When power is first applied, the display counts from 0 to 20. A beep
sounds, then the following displays may appear:
z
0
– number of messages
z
Al – outgoing message 1 not recorded
z
A2 – outgoing message 2 not recorded
z
Lo
–battery is weak or missing
z
Ph –phone line not connected, or phone in use
On a wall plate
1. Plug the supplied short
telephone cable into the
TEL LINE port on the
back of the unit.
2. Plug the supplied AC
adapter’s barrel plug into
the AC 9V 400mA jack
on the back of the unit.
3. To mount on a wall plate, route the adapter cord hanging
down and the other end of the short telephone cable through
the center of the bracket. Insert the tabs on the top end of the
bracket into the slots on the bottom of the unit, then push the
tab on the bottom end of the bracket into the lower slot on the
unit.
PT1000
Operator’s Guide
6