COMEX S.A.
CMX: 202023.01 EN
7
2.
Highlight the ATS PDU device from the list and select Tools => Device Setup from the menu.
3.
Configure the IP Address, Subnet Mask, and Gateway Address to match your network settings.
4.
Enter the user name and password of the ATS PDU device at the Authentication menu.
Note: The default username is “admin” and the default password is “admin”.
For further information and installation instructions, see Appendix B.
Option 2: DHCP Server
1.
Ask your administrator if there is DHCP server on the LAN.
2.
Make sure the DHCP is Enabled.
3.
Make sure the network connection is ready and power on the ATS PDU.
4.
The ATS PDU will obtain an IP address from the DHCP server automatically.
Option 3: Hyper Terminal or Terminal Emulator
In order for Hyper Terminal to interface with the ATS PDU, the PC/server must be
connected directly to the ATS PDU via the serial port.
1.
Use the included RJ45/DB9 serial port connection cable, attach one end to the serial port on
the front of the ATS PDU, and the other end to the PC/server.
2.
Open the Hyper Terminal software on your PC and select a name and icon for the connection.
3.
Setup the COM port settings using the following values
Bits per second: 38400
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
4.
Press Enter to enter the Authentication menu.
5.
Enter the user name and password of the ATS PDU device at the Authentication menu.
Note: The default username is “admin” and the default password is “admin”.
For further information and configuration via Hyper Terminal, see Appendix A-Hyper Terminal.
Power Cord Retention Clip Installation For ATS PDU
Input Power Cord Retention Cable Clip Installation
Step 1. Remove the screw next to the inlet.
Step 2. Attach the Cable Tie on the ATS PDU and secure it with the screw removed in the previous
step.
