COMEX S.A.
CMX: 202023.01 EN
14
Appendix A
Hyper Terminal software can be used for basic ATS PDU configuration. It utilizes a text-based interface
and menu system. Navigation through the interface is done by typing the number of the menu option
and pressing the Enter key. For COM port setting values, please refer to p.9 Option 4: Hyper Terminal
or Terminal Emulator section.
Note: The session will timeout and logout after 3 minutes of inactivity. Menu options are shown below:
[Main Menu]
1.
Utility Configuration
2.
Outlet Manager (Switched Series Only)
3.
Load Configuration
4.
Network Settings
5.
System Configuration
6.
Account Settings
7.
Configure System to Default
8.
Logout
[Utility Configuration]
1.
Preferred Source: A
2.
Sensitivity: High
3.
Voltage Range: Medium
4.
Frequency Deviation: 1 Hz
5.
Nominal Voltage: 230 V
6.
Wide Voltage Range: 30 V
7.
Medium Voltage Range: 23 V
8.
Narrow Voltage Range: 16 V
9.
Set Load Restriction (Switched Series Only)
[Outlet Manager]
1.
Outlet Control
2.
Outlet Configuration
[Load Configuration]
1.
Device Threshold Configuration
2.
Bank 1 Threshold Configuration
3.
Bank 2 Threshold Configuration
4.
Bank 3 Threshold Configuration
[Network Setting]
Physical MAC Address: 00-0C-15-00-00-01
1.
System IP: 192.168.20.240
2.
Subnet Mask: 255.255.255.0
3.
Default Gateway: 192.168.20.254
4.
DHCP: Enabled
5.
Http Port: 80
6.
Http Access: Enabled
[System Configuration]
1.
Name: System Name
2.
Location: Server Room
3.
Contact: Administrator
[Account Setting]
1.
Administrator
[Configure System to Default]
Sure to Configure System to Default
1.
Reset ATS
2.
Reset ATS (TCP/IP Settings Reserved)
