COMEX S.A.
CMX: 202023.01 EN
17
Getting Started
The Power Device Network Utility scans the network for devices with MAC addresses that match
PMCARD network hardware. Once found, the device(s) can then be figured with a specific IP address,
subnet mask, and gateway address. This allows the device(s) to function properly on the network and
interface.
Step 1. Select the appropriate ATS PDU from the Equipment List (Shown in Figure 6).
Figure 6. Equipment List
Note: If the ATS PDU does not appear on the list, click the Refresh button to rescan the network. If it
still does not appear, ensure that the ATS PDU is turned on and is installed correctly.
Pressing Stop will cancel the scan/refresh process.
Note: If your computer has a software firewall installed, you may see a Windows Security Alert
message (Shown in Figure 7).
In Windows XP SP2, the default firewall alert message is shown as Figure 7. You need to allow the
Power Device Network Utility access through the firewall.
Figure 7. Windows Security Alert
Step 2. Assign a valid IP Address to the ATS PDU
With the appropriate device selected from the Equipment List, open the Network Settings menu
(shown in Figure 8) [Tools=>Device Setup]. In the Device Network Setting Menu, enter a valid IP
address, subnet mask, and gateway address to setup the ATS device.
