Instructions and operating manual sweeper CSW 1300 B (translated from original instructions)
pag. 49
u
FILTER SHAKE BUTTON:
Detail 1
.
This is used to make the suction filters vibrate electrically (to clean them), by means of an electric
vibrator; it must be pressed at least
6/7
times for
8/10
seconds every time (this procedure must be carried
out before operating the machine, before emptying out the debris hopper and the motor must be off).
u
HORN BUTTON:
Detail 2
Press this button to sound the horn.
u
WORK LIGHT SWITCH:
Part. 3
This is used to turn the work lights on.
u
INTAKE SWITCH:
Part. 4
Used to switch the intake motor on or off. It should be left off whenever you wish to shake the filters
or if you have to run the machine over damp surfaces (with the engine running).
u
HOUR METER:
Detail 5
An instrument that displays the number of hours the machine has been working, the condition of
the batteries and the speed.
IT IS ADVISABLE NOT TO WAIT FOR THE “AL4 P” ERROR TO APPEAR ON THE DISPLAY SCRE-
EN BEFORE CHARGING THE BATTERIES, BUT TO PROCEED WITH THE CHARGING OPERATION
WHEN THERE ARE STILL AT LEAST 3 BARS ON THE DISPLAY.
u
IGNITION KEY:
Detail 6
This switches on the entire control panel, especially the potentiometer, for driving; it is possible to
drive without working.
u
GEAR SHIFT:
Detail 7
The gear selector lever is used to make the machine travel forwards or in reverse. When the selector
is in the forward drive position (in the direction of the forwards arrow). By pressing the pedal
Detail 3 Fig. 7
the machine will travel forwards. Vice versa, when the selector lever is in the back position, by pressing the
pedal the machine will travel in reverse.
For safety reasons, the speed of the machine in reverse drive is
much slower.
By leaving the selector in the central position, the machine will not go into forward or reverse
drive.
