IE-SNC-P85x1-11
20
Communication protocols
Short introduction to communication protocols of the device. To use some
communication protocols is necessary software, which can use the protocol. This
software is not included. Detailed description of protocols and application notes
can be found in the manual appendix.
Website
The device supports displaying of measured values, history graphs and configuration using
web browser. History graphs are based on HTML5 canvas. Web browser must support this
feature for proper function of graphs. Firefox, Opera, Chrome or Internet Explorer 9 can
be used. If the device has IP address
192.168.1.213
type into your browser
http://192.168.1.213
. Using TSensor software or web interface can be set automatic
webpages refresh in interval. The default value is 10sec. Actual measured values can be
obtained using XML file
values.xml
.
Values from history can be exported in CSV format. History storage interval can be set
using TSensor software or web interface. History is erased after every reboot of the device.
Reboot of the device is performed when the power supply is disconnected and also after
configuration change.
The device allows you to customize the design of web pages. Details of how to change the
design, you can find in the manual appendix. Manual appendix can be obtained from the
manufacturer’s website.
SMTP – sending e-mails
When measured values are over the set limits, the device allows send e-mail to a maximum
of 3 addresses. E-mail is send when alarm condition on the channel is cleared or a
measuring error occurs. It is possible to set repeat interval for email sending. For correct
sending of e-mails it is necessary to set IP address of SMTP server. SMTP authentication is
supported but SSL not. Standard SMTP port 25 is used by default. SMTP port can be
changed. Contact your network administrator to obtain configuration parameters of your
SMTP server.
E-mail sent by the device can not be answered.
Chapter
4
