Section 11 - Installation of Car Seat in Vehicle (continued)
37
Adjust Base installation angle to center Bubble on the black line
for infant’s weight. To adjust see “Adjusting Base for Proper Car Seat
Recline” section.
Once Bubble is centered on the black line for infant’s weight,
proceed with installation.
Connect Lower Anchor Connectors to vehicle lower anchors:
- Position red release button of Push-On Connector
facing away from Base and wording on back side
of connector facing Base. If connector is not in
this position, turn connector over.
- Position the slot of the Push-On Connector onto
the vehicle anchorage. Push connector in to lock
onto the vehicle anchorage
(fig. j)
. You should
hear a click.
- Pull on connector to be sure it is locked onto the
anchorage .
- Repeat for connector on opposite side.
9
10
(fig. j)
1
2
1
2
CCS0262D 090209.qxd:CCS0262D 090209 9/2/09 1:14 PM Page 38
