Section 14 - Vehicle Seat Belts (continued)
72
Slide locking clip onto vehicle seat belts approximately
1/2 inch (1 cm) away from latch plate
(fig. b)
.
Slide vehicle belt back into vehicle lap belt guide
or belt path opening in base.
- Check to be sure vehicle lap belt is still
correctly routed throughout entire belt path.
Re-buckle vehicle seat belt.
Test installation to see if car seat or base is secure.
If not secure, additional vehicle seat belt tightening
may be necessary.
• Unbuckle vehicle seat belt.
• Hold vehicle seat belts together and remove locking clip.
• Shorten length of vehicle lap belt portion slightly by pulling
vehicle lap belt through latch plate.
• Re-attach locking clip.
• Buckle vehicle seat belt.
HINT:
Press car seat or base down into vehicle seat cushion to
help buckle vehicle seat belt.
Test installation to see if car seat or base is secure, if not secure,
repeat above steps until car seat is secure.
4
5
6
7
(fig. b)
1/2 inch (1 cm)
CCS0262D 090209.qxd:CCS0262D 090209 9/2/09 1:14 PM Page 73
