Section 11 - Installation of Navette 22 Infant Car Seat
(continued)
25
Rear center seating position:
LATCH Lower Anchorages with 11 inches (280 mm) spacing may not
be available in your vehicle in the rear center seating position. If use
of the rear center position is preferred, use the vehicle seat belt to
secure the car seat, go to Section 11b.
After selecting a seating location, if vehicle seat back is adjustable,
adjust vehicle seat back into most upright position or position specified
in the vehicle owner’s manual.
Unsnap Vehicle Belt Guide Covers and tuck covers inside seat.
Place car seat rear-facing on vehicle seat. Keep
handle up in carry position.
Remove Lower Anchor Connectors from
LATCH storage loop on side of seat pad.
If the Lower Anchor Belt is too short,
rotate the Lower Anchor Belt Adjuster
upwards to loosen the Lower Anchor
Belt
(fig. a)
.
5
(fig. a)
Lower
Anchor
Belt
Lower
Anchor
Belt
Adjuster
Pull
2
3
6
4
Route the Lower Anchor Belt over the car seat
threading the Lower Anchor Belt under the
vehicle belt guides
(fig. b).
Lower Anchor
Belt Adjuster should face away from
car seat.
Be sure lower anchor belt is not twisted.
Connect lower anchor hook-on
connectors to vehicle lower anchors:
- With hook-on connector opening
facing down , position the opening
of the connector over the vehicle lower
anchorage. Push down and then pull
out on the connector to lock it onto the
vehicle anchorage
(fig. c)
. You should
hear a click.
- Pull on connector to be sure it is locked
onto the anchorage.
- Repeat for connector on opposite side.
(fig. b)
Vehicle
Belt
Guide
(fig. c)
1
2
3
6
Section 11 - Installation of Navette 22 Infant Car Seat
(continued)
26
LATCH
Belt
1
3
2
