47
DAILY MAINTENANCE
REPLACEMENT OF THE SQUEEGEE RUBBER
If the squeegee rubber is worn and does not dry well, it is possible to
change the drying edge proceeding as follows:
1.
Push and rotate the fixing plates
2.
Slip off the rubber blade and the rubber itself
3.
Turn the rubber upside-down and if necessary, replace it
4.
Adjust the squeegee height as indicated in “ADJUSTMENT HEIGHT
SQUEEGEE SUPPORT” under “MACHINE PREPARATION”
5.
Reassemble everything repeating inversely above operations
DISASSEMBLY OF THE BRUSHES
1.
Connect the battery connector if it is not connected
2.
Turn the key into position ON
3.
With the manipulator lift the brushes base
4.
Turn the key into position OFF and take if off from the instrument board
(to carry out the operations of brush disassembly with connected
current can cause damage to the hands)
2
1
3
4
5.
With the brushes base in lifted position, rotate the brush until it comes
off from the brush plate seat as shown in the figure. The figure shows
the rotating direction for the disassembly of the right brush, the left one
has to be rotated inversely.
WARNING!
This operation has to be carried out using gloves
to protect from contact with dangerous solutions
.
