37
MACHINE PREPARATION
8.
SQUEEGEE
The squeegee, which is packed separately from the machine, should be assembled as
shown in the figure, couple the stud bolts (1 - C85B) or the nuts (C100B) of the
squeegee into their seats on the squeegee support and fix them with a key CH17.
Fit the suction hose (2) into its coupling and fix it with the appropriate clamp.
During working operation, the rear rubber has to work slightly tilted backwards and this
equally in its whole length for about 5 mm.
If it is necessary to increase the rubber bending in the central part, tilt the squeegee
body backwards, loosen the adjuster nut (1) and rotate the knob (2) counterclockwise. If
the rubber bending is to be noticeable at the sides of the squeegee, loosen the adjuster
nut (1) and rotate the knob (2) clockwise. After regulations have been done fix the
adjuster nut.
9.
ADJUSTMENT HEIGHT SQUEEGEE SUPPORT
The squeegee has to be regulated in height depending on the wearing of the rubbers. To
adjust this:
1.
Loosen the ring nut (1)
2.
With a key CH17 rotate the castor wheel through the nut (2) clockwise to lift the
squeegee and counterclockwise to lower it
3.
Fix the ring nut (1)
NOTE:
The right and left castor wheels have to be regulated equally.
