42
PERFORMANCE
13.
Push forward the brushes manipulator (1) so to lower the base. During the descent,
the signal lamps of the actuator and the brushes motor come on. The brushes base
will be in its working position when the yellow signal lamp (2) comes off.
2
1
14.
Press the accelerator pedal. The machine begins to move, the squeegee begins to
lower itself and the suction motor comes on.
During the first metres of operating, check that the brushes pressure is suitable (see
further on under “BRUSHES PRESSURE”), that the quantity of the detergent solution
is sufficient and that the squeegee dries perfectly.
The machine will now start working efficiently until the detergent solution runs out.
Immediately disconnect the emergency lever (1) situated on the left side from the
operator and apply the emergency brake (2), whenever the machine develops
operating problems when it is working.
These commands disconnect all the functions
on the machine. To start the machine again, once the problem has been solved, turn off
the key (3), reconnect the connector (1), switch on the key (3) and lower the parking
brake lever (2).
The machine will not start if the operator is not properly seated.
When the solution tank is empty, the signal lamp on the instrument board comes on.
When the recovery tank is full, the suction motor stops. To start it up again, even if the
tank has been emptied, it is necessary to first turn off the main switch key and then on
again.
