11
Treadmill Hardware Manual 1011-0002 v1.02
•
Fold the lid onto the cover.
•
Place the holes of the cover over the posts in the front of the treadmill and secure with the two
thumbnuts.
•
Unfold the lid onto the treadmill and secure with the 2 clips.
•
Place the feces tray underneath the treadmill below the platform and treadmill belt.
This completes the assembly of the Exer 3/6 Treadmill.
2.2.2 Downhill Running Adapter
If the Exer 3/6 Treadmill came with the Downhill Running Adapter, then the system will contain the following:
1 x Right leg with rubber foot.
1 x Left leg with rubber foot.
2 x Braces for the legs.
9 x #6-32 x 3/8-in screws.
9 x #6-32 hex nuts with nylon locking inserts.
To setup the Downhill Running Adapter, do the following:
•
Remove any protective plastic film that may cover the pieces of the Downhill Running Adapter.
•
Raise the front of the treadmill so the treadmill will reset entirely on the rear panel. Remove the
Inclination Rod with spring pin and set aside.
•
Using the Philips screwdriver and 5/16in wrench, remove both feet from the bottom of the treadmill.
Summary of Contents for Exer 3/6
Page 2: ......
