PLC Battery Low:
PLC battery is low and may cause the blender to lose both the program
and the blender configuration. Notify Maintenance immediately.
Figure 45: Typical “PLC Battery Low” Alarm Screen
PLC BATTERY LOW
Blender Powered On/Off:
These are only logged in the Alarm Log and does not cause a
pop-up message or audible alarm. Each time the blender is powered on or off, the time and
day is logged to the Alarm Log.
Inventory Cleared:
This is only logged in the Alarm Log and does not cause a pop-up
message or audible alarm. Each time the inventory is cleared, the time and date are logged to
the Alarm Log. An alarm will sound and a screen will pop up when Auto. Inventory
Shutdown has been reached.
E-Stop Screen:
The blender is equipped with an E-stop switch that removes the power from
all mechanical outputs. The E-Stop Screen appears along with an audible alarm whenever
the E-Stop is activated. The operator can not access any screens until E-Stop is deactivated.
The Panel View will then put the screen back to the display that the operator was on prior to
hitting the E-Stop.
Figure 46: Typical “E-Stop Activated” Alarm Screen
BF1-615.3
Chapter 4: 3BOperation
58 of 101
Summary of Contents for 882.00273.00
Page 22: ...Figure 11 Typical Operator Screens BF1 615 3 Chapter 2 1BFunctional Description 22 of 101...
Page 23: ...Figure 12 Typical Setup Screens BF1 615 3 Chapter 2 1BFunctional Description 23 of 101...
Page 24: ...BF1 615 3 Chapter 2 1BFunctional Description 24 of 101...
Page 75: ...Mixer Sub Assembly BF1 615 3 Chapter 7 6BAppendix 75 of 101...
