Coleman 2302-A Instruction Manual Download

Page: 8 / 41

Use and Operation (continued)

SHUTTING OFF THE HEATER

1.  Turn the control knob clockwise to the “OFF” position.
2.  Switch off the power button on the display panel.
3.  Turn the main power switch to “OFF” position (available on model 2302-A only).

IMPORTANT:

User must not change the order of the shut-off-operation sequence. Alwasy shut off the burner and

gas supply by turning the control knob to the “OFF” position first, then switch off the power button.

STOPPING THE HEATER TEMPORARILY

Due to safety reasons, there’s no switch to pause the water flow while taking a shower. You can only shut off the main burner by turning the control knob

clockwise back to the ignition position “ PILOT” to conserve gas, the pilot light remains lit, the pump & water keeps running. To resume heating the water, turn

the control knob counter-clockwise to a setting between “MAX” & “MIN” position.
Or you may shut off the heater completely by following steps in above section “

Shutting Off the Heater

”, then restart the whole ignition process illustrated in

section “

Lighting the Heater

”.

CLEANING INSTRUCTIONS

1. In a clean container mix two-gallons (7.5 L) of water with 12

oz. (340 g) of calcium, lime, and rust remover (available at the

cleaner section of hardware, general merchandise and food

stores).

2. Place the pump and shower in the container with the water/

solution. The label “This Side Up” on pump should be facing up.

3. Start the heater by following instructions in section “

Lighting the

Heater

” and turn the control knob to a “warm” setting.

4. Circulate the water/solution through the heater for 2 minutes,

then turn off heater by turning the knob clockwise to the “off”

position and switching off the power button on display panel.

5. Dispose of the cleaning solution in a sink or other drain, do not

dump on the ground.

6.  Fill container with 2.4 gallon (9 L) of clean water.
7.  Place the pump and shower in the container with the water.
8.  Turn the heater on and circulate the clean water through the

water heater for 2 minutes at the “cool” setting,

9. Turn the heater off.
10. Repeat steps 6-9 with another batch of clean water.
11. Clean the screen at the pump water inlet to remove the residue that may clog the pump. See maintenance section on page 8 for instructions.

CHARGING USB COMPATIBLE DEVICES

(Available on

model 2302-A

only)

You may charge 2 mobile phones at the same time by connecting the phones to the USB ports on the

heater. The capacity of the rechargeable battery inside the heater is 2000 mAh, which could charge a

1570 mAh mobile phone (iPhone 5s) one complete cycle.

IMPORTANT:

USB ports only work when the Main Power Switch is turned on. Do not connect

devices to the USB ports on the heater when the heater is in operation or is still hot to touch. Do

not connect devices to the USB ports on the heater if there’s a “LOW BATTERY” indication on the

Display Panel (see chart of indicators in section