MVS-8600 Hardware
2
62
MVS-8600 Hardware Manual
Hirose HR10 Connector P3
The Hirose HR10-10R-12S connector on the faceplate carries trigger, strobe, and
encoder signals, as well as camera power and ground lines. This connector is designed
to be used with a Cognex cable connecting to the I/O Connection Module, part number
800-5885-1.
The pin numbering for the Hirose connector on the MVS-8600 faceplate is shown in
Figure 21.
Figure 21. Pin numbering for Hirose HR10 connector
All signals on the Hirose HR10 connector are duplicated on either the P4 or P6
connectors, or on both.
Connect wires from trigger, strobe, and encoder devices to the I/O Connection Module
as described in
Connecting Parallel I/O Devices
on page 29. Cognex does not
recommend connecting device wiring directly to the Hirose HR10 connector.
1
2
3
4
5
6
7
8
9
10
11
12
1
2
3
4 5 6
7
8
9
10
1112
To bus connector
Summary of Contents for MVS-8000 Series
