Coffee Queen CAFE ELITE, Technical Manual

Page: 12 / 56

CAFÉ ELITE
12
INSTALLATION AND START-UP
Positioning
Machine startup procedure
minimum
10cm
Place the machine on a flat horizontal surface that will
support the weight of the machine.
Connect the electrical plug to a separate grounded wall
socket.
Make sure air is able to circulate behind the
machine (minimum 10cm).
Note
Connect the water to the top cabinet on the
machine.
Connect the supplied water hose to the cold water
connection using a ½’’ R-connection. When pushing
the machine into position make sure there is no
interference to the hose to ensure proper water
flow.
If the inlet hose is new, flush the system with water
first to remove copper shavings. These can damage
the inlet valve.
The new tube set supplied with the appliance must be
used. Old tubes may not be re-used. Connection to a
closable valve is recommended.
Min. water pressure; 2 bar (200kPa).
Max. water pressure: 8 bar (800kPa).
Open the water tap.
Connect the mains cable to the machine (A) and insert the plug to a earthed wall socket.
Switch on the power switch on the rear of the machine. See figure.
The display indicates
Low Water Level
Press Enter Key
Press the
E
button.
The water tank will now automatically fill with 5 litres of water. The element will not be powered until
the water reaches the level sensor.
Set temperature is 85º Celsius.
Once the water heating is complete “Low temp” text will disappear from the display. (The display text
will start to rotate between these two screens
COFFEE QUEEN
and
AT YOUR SERVICE
)
A