English
18
~
~
~
~
~
~
~
~
Nota
: Simultaneously pressing
+
and – buttons will return the calibration value to 128 (default).
UPLD Function (Upload)
this function allows to upgrade the firmware of
Stage Lite Led sc
only by DR1 or DR1 Plus and a Personal Computer. Read DR1
or DR1 Plus manual for further information.
DULD Function (Download)
this function allows to download the software from
Stage Lite Led sc
only by DR1 or DR1 Plus and by a Personal Computer. Read
DR1 or DR1 Plus manual for further information.
9. Error messages
If a malfunction occurs,
Stage Lite Led sc
has a self-diagnostic system that will show the error message on the display. The
following table will explain in detail the most common errors. If, despite of suggested intervention, the problem persists, call the
Coemar Service center near you.
Error message
Description and suggested solution.
Data error.
The initial configuration settings are faulty or have been loaded incorrectly. The projector has loaded its default
configuration. Turn the projector off and on again and if the error persists, it means that the EEprom is either defective or
absent; refer to your Coemar service center for the replacement.
DMX address error.
The projector is not receiving all the DMX channels necessary for its operation. Check the DMX address
and the control consolle operation. Note that some controllers may not generate all 512 channels of signal.
Master mode error.
This message indicates that the user has attempate to set the unit to MASTER mode whilst DMX signal is
still being received. Detach any DMX control signal or remove MASTER mode settings on other units in the DMX chain.
With DMX signal connected
DMX press for 10” enter and
menu buttons together: the
display will show the folowing
diagram.
Alignment of red led at minimum intensity
Alignment of green led at minimum intensity
Alignment of blue led at minimum intensity
Alignment of white led at minimum intensity
Alignment of red led at maximum intensity
Alignment of green led at maximum intensity
Alignment of blue led at maximum intensity
Alignment of white led at maximum intensity
Software upload from DR1 +
Software downolad to DR1 +
To end the electronic calibration procedure and to record it.
Reading of progress value
Reading of progress value
