English
13
7. Turning on the projector
After having followed the preceding steps described, proceed with the power supply and turn on the projector connecting it to the
mains power.
The display the software version installed on the internal microprocessors:
For example, when switched on
Stage Lite Led sc
may show:
(actual software version installed)
If the address continues to blink and the “NO DMX SIGNAL” message appears, it means that the DMX signal has not been
received. Check the connection cable and the mixer functioning.
7.1 DMX address of the unit
Each projector uses 8 address channels for its complete operation and is controlled by a DMX 512 signal (for further information,
see section 7.2, DMX functions).
DMX addressing
When powered up initially, each projector will show A001, which indicates DMX address 001; a projector thus addressed will
respond to commands of channel 1 to 8 from your DMX 512 controller. A second unit must be addressed as A016, a third as A024
and so on. The operation must be carried out on every
Stage Lite Led sc
which has an address different from A001.
Altering DMX address.
1.
Press the + or – button until the display shows the required DMX address. The digits on the display will blink to indicate that the
variation has not been registered.
2.
Press the
enter
key to confirm your selection. The digits on the display panel will cease to blink and the projector will now
respond to the new address.
Note: by holding the + or – button down the scrolling will be faster; thus allowing a faster selection
WARNING!
If you alter the DMX address with no DMX signal connected, the digits on the display panel will continue to flash
even after you have pressed ENTER button to confirm the address.
