This function allows for the transmission of bidirectional data with the
DR1
(cod.
CO9703
). Via the
DR1
(display remote) it is possible
to remotely access, view and alter all the fixture’s parameters and settings.
The
DR1
remote display unit allows the user to:
To initiate communications with the
Pin Lite LED
the
DR1
must be installed into the DMX signal chain between the fixture and the
controller following the instructions located internally on the unit.
The
DR1
dip-switch must be set to the
ON position
; from this point on, dip-switches 1 to 128 take on the task of assigning an iden-
tifying value (ID) to the fixture. They no longer set the fixture’s DMX address, which is done by the
DR1
. The maximum number of
unique IDs available in the
DR1
system is 250; dip-switch 256 has no functionality.
An example of a possible configuration is shown below:
10.1. Setting up functionality via DR1 (FUNC)
Using the inbuilt functionality of the
Pin Lite LED
via the
DR1
, it is possible to alter the function settings of the fixture. The following
diagram illustrates the menu navigation system of the
DR1
in
FUNC
.
RED
Test red channel
☞
menu
FUNC
MEAS
AOO1
MODE
☞
+
o
--
☞
+
o
--
TEST
test
Function test
DFSE
default functions setting
To set all the functions at the original values,
but for DMX address and for working time.
RESE
reset
Reset function
☞
+
o
--
☞
+
o
--
☞
enter
☞
+
o
--
☞
enter
☞
+
o
--
☞
+
o
--
☞
+
o
--
☞
+
o
--
es.
0127
☞
enter
☞
enter
☞
+
o
--
☞
enter
☞
enter
es.
0127
☞
enter
☞
enter
☞
+
o
--
es.
0127
☞
enter
☞
enter
☞
+
o
--
es.
0127
☞
enter
☞
enter
☞
+
o
--
SURE
☞
enter
☞
enter
0020
SURE
0020
0020
0020
☞
enter
-– -– -– -–
reset activation
GREE
Test green channel
BLU
Test blu channel
STRB
Test strobo
STOR
To record the scene of the unit.
If DMX signal is not applied,
the recorder setting will appear
at the end of reset operation
when the unit is switched on.
Pin Lite LED
set to ID 13 and
DR1 active
configured by setting dip-switch
DR1
to
ON
and dip-switches
1, 4
and
8
to
ON
256
auto
test
light on
DR1
1
2
4
8
16
32
64
128
Edit and set (MODE):
1) DMX address
2) function mode
Execute (FUNC):
1) Function test
2) Software update
3) Color alignment
Monitor (MEAS):
1) the current Software Version loaded
2) temperature
3) led operating life
4) projector operating life
5) presence and characteristics of incoming DMX 512
6) error messages
7) ID code
ATTENTION!!
All the function in this chapter are exclusively activateable from DR1.
10. DR1 function
16
English
Summary of Contents for PIN LITE LED
Page 1: ......
