This function can be used to determine the operating mode of the projector (either
STAND ALONE
or
MASTER/SLAVE
), make pro-
gram selections or alter the crossfade times. Setting this function to on inhibits control via DMX signal.
9.1. MASTER/SLAVE mode
In MASTER/SLAVE mode, it is possible to control, via a projector set as MASTER, a series of
Pin Lite LED
units set to act as SLAVE fixtures.
The table below displays the settings required for fixtures to be connected in this manner.
To configure a
Pin Lite LED as MASTER
is simply a matter of setting the
Auto
dip-switch
to the
ON
position and selecting a program for it to follow by making a selection from the
following dip-switches:
1-2-4-8-256
. There are 4 programs which can be selected.
- dip switches
1-2-4-8
select programs 1, 2, 3, and 4 respectively.
- dip-switch
256
runs all four programs sequentially
To configure a
Pin Lite LED
as
SLAVE
is simply a matter of setting the
Auto
dip-switch to
the
ON
.
All
other dip-switches should be set to
OFF
.
Pin Lite LED
set to
SLAVE
256
auto
test
light on
DR1
1
2
4
8
16
32
64
128
SLAVE
ATTENTION!!
It is only possible to select one program at a time.
Pin Lite LED
set as
MASTER
running program 1
256
auto
test
light on
DR1
1
2
4
8
16
32
64
128
MASTER
9. Auto function
14
English
Summary of Contents for PIN LITE LED
Page 1: ......
