6
The fixture may operate at voltages ranging from 100-115-208, 230 or 240V .at 50 or 60 Hz;
coemar
factory presets (barring spe-
cific requests), a voltage of 230v and a frequency of 50 Hz. This preset is indicated on the sticker located on the base of the projec-
tor, as indicated in the following diagram.
If the specified voltage and frequency do not match those of the country in which you are operating, follow the instructions in sec-
tion
19
of this manual. “
Altering the operating voltage and frequency
”
Incorrect voltage and frequency selection will detrimentally affect the operation of the projector.
Mounting
The support structure should be of sufficient strength to support the weight of the fix-
ture.
ColourCyc 250 LX
is able to operate in any position.
The 3 holes in the base of the
ColourCyc 250 LX
allow for the attachment of a “c”
clamp at any position .
Do not install the fixture in a position where unauthorised personnel can tamper with
the fixture or its settings.
Incorrect installation may cause irreparable damage to the fixture and will immediately
void the warranty.
Safety chain
The use of a safety chain (cod. 069) affixed to the
ColourCyc 250 LX
is recommended, uti-
lising the appropriate holes (
A
) on the yoke of the
ColourCyc 250 LX
and to the primary
suspension point.
If using an after-market safety chain not manufactured by
coemar
, ensure that it is of sufficient
rating to hold the weight of the unit.
Protection against liquids
The projector contains electric and electronic components that must not come into contact
with water, oil, or any other liquid.
Protection against dust
Dust and dirt can shorten the life of the unit appreciably;
ColourCyc 250 LX
has no speci-
fic protection devices against dust and dirt and regular cleaning is recommended to avoid any
build up within the projector..
Risk of fire
Each fixture produces heat and must be installed in a well-ventilated position. The minimum
recommended distance from flammable material is: 0.5m. Minimum distance from the object
being illuminated is: 2 m..
Forced ventilation
There are several ventilation openings in the projector body and the base for air flow to occur. These should never be obstructed
under any circumstances!
Should this occur, the result may be overheating of the unit which will seriously affect the proper operation of the unit.
Ambient temperature
The projector must be installed in a well-ventilated area; the ambient temperature should not exceed 35°C.
6. Installation
factor
y set main at:
100V
115V
208V
230V
240V
50Hz
60Hz
5. Operating voltage and frequency
English
325mm
12,80”
220mm
8,66”
110m
m
4,33”
110m
m
4,33”
