After having followed the preceding steps, turn on the DMX 512 controller which will be used to control the fixture and then turn
on the unit via the
power
switch located on the base of the unit.
If you have chosen to control the functions of the
ColourCyc 250 LX
via a DMX 512 contrller, you should power up the control-
ler prior to the fixtures.
The fixture will perform a reset on all the internal and external motors. This will last some few seconds, after which it will be subject
to any incoming external signal.
Ventilation
The projector is fitted with 2 fans for forced cooling of the unit.
The two fans are directly controlled by the on-board software and may be switched off on powering up, depending upon the set-
tings of the unit’s dip switches. They may never be switched off when the lamp is turned on.
To turn the fans on, you will need to switch on the lamp or alter the
fan on
dip switch setting to
ON
.
DMX 512 signal reception
Upon being powered up, the projector will proceed with its reset function. On completion of this, the led will flash if the projector
is correctly receiving
DMX 512
signal.
If the led remains off, the projector is not receiving signal correctly. Check the cabling and the functioning of the controller.
Turning on the power with no dmx signal connected
After being powered up, the projector will perform a reset. When completed, the led will remain off, indicating that the fixture is not
receiving
DMX 512
control signal.
test fan ON lamp ON
DR1
remote
motor
calibration
shutter/
strobe inhibit
fan
alert
lamp
status
DMX
ON
ON
reset
dip-switches
DMX addresses, ID personality or built in program and speed
1
2
4
8
16
32
64
128
256
PR 1 PR 2 PR 3 PR 4
T 1
T 2
SP 1
SP2 all PR
all OFF for slave
OFF - DMX addressing, ID personality
ON - built in program control
9. Powering up
10
English
