4
Fire prevention:
1. CF 7 W
ash
Z
oom
X
utilises a Philips MSR 700 SA; the use of any alternative lamp is not recommended and will null and
void the fixture’s warranty.
2.
Never locate the fixture on any flammable surface.
3.
Minimum distance from flammable materials: 0,5 m.
4.
Minimum distance from the closest illuminable surface: 2 m.
5.
Replace any blown or damaged fuses only with those of identical values. Refer to the schematic diagram if there is any
doubt.
6.
Connect the projector to mains power via a thermal magnetic circuit breaker.
Prevention of electric shock:
1.
High voltage is present in the internals of the unit. Isolate the projector from mains supply prior to performing any func-
tion which involves touching the internals of the unit, including lamp replacement.
2.
For mains connection, adhere strictly to the guidelines outlined in section 7 of this manual.
3.
The level of technology inherent in the
CF 7 W
ash
Z
oom
X
, requires the use of specialised personnel for all service appli-
cations; refer all work to your authorised
coemar
service centre.
4.
A good earth connection is essential for proper functioning of the projector.
Never operate the unit without proper earth connection.
5.
The fixture should never be located in an exposed position, or in areas of extreme humidity. A steady supply of circulating
air is essential.
Protection against ultraviolet radiation:
1.
Never turn on the lamp if any of the lenses, filters, or the carbon fibre housing is damaged; their respective functions will
only operate efficiently if they are in perfect working order.
Never look directly into the lamp when it is operating.
Safety:
1.
The projector should always be installed with bolts, clamps, and other fixings which are suitably rated to support the wei-
ght of the unit.
2.
Always use a secondary safety chain of a suitable rating to sustain the weight of the unit in case of the failure of the pri-
mary fixing point.
3.
The external surface of the unit, at various points, may exceed 150°C. Never handle the unit until at least 10 minutes
have elapsed since the lamp was turned off.
4.
Always replace the lamp if any phusical damage is evident.
5.
Never install the fixture in an enclosed area lacking sufficient air flow; the ambient temperature should not exceed 35°C.
6.
A hot lamp may explode. always wait for at least 10 minutes to elapse after the unit has been turned off prior to attemp-
ting to replace the lamp.
Always wear suitable hand protection when handling the lamp.
Protection against penetration by foreign objects
1.
The fixture’s protection rating against penetration by solid or liquid objects is IP 20; the projector is classified as ordinary
device.
2.
Never install the fixture exposed to rain, or highly humid environments with lack of constant ventilation.
3. Important safety information
English
