13
2012 Audiovox Electronics Corporation. All rights reserved.
4 Pin Power Harness
1
RED
BATTERY 12V ( + )
Locate 1 of the vehicle’s constant 12 Volt battery wires at the ignition switch.
Verification:
This wire will register ( + ) voltage in all positions of the ignition
switch.
Connect the RED wire to the constant 12 Volt battery wire.
NOTE:
Remove all fuses until all connections are made.
2
GREEN
STARTER INPUT - KEY SIDE
3
PURPLE
STARTER OUTPUT - MOTOR SIDE
Locate the vehicle starter wire.
Verification:
This wire registers voltage
only
when the key is turned to the
START position. Cut the vehicle's starter wire in half.
Verification after starter wire is cut:
KEY SIDE of starter wire registers voltage when the key is turned to the
START position.
MOTOR SIDE of starter wire registers no voltage.
Connect the GREEN wire to the KEY SIDE of the vehicle starter wire at the ignition
switch harness.
Connect the PURPLE wire to the MOTOR SIDE of the vehicle starter wire.
Locate the vehicle’s ignition wire at the ignition switch.
Verification:
This wire registers voltage when the key is turned to the ON (or
RUN) position. The voltage does not drop out when the key is turned to the
START (or CRANK) position.
Connect the PINK wire to the vehicle’s Ignition wire.
This wire is also used for Ignition 1 Output.
22
ORANGE
ARMED OUTPUT ( - )
This wire will have a continuous ( - ) 500mA output when the system is Armed. This
wire is typically used for controlling window modules or additional sensors.
4
PINK
IGNITION 1 INPUT/OUTPUT ( + )
