14
2012 Audiovox Electronics Corporation. All rights reserved.
6 Pin Start Harness
1
RED
BATTERY 12V ( + )
Locate the vehicle’s constant battery wire(s) at the ignition switch.
Verification:
These wires will register ( + ) voltage in all positions of
the ignition switch.
Connect the RED wire to the vehicle’s battery wire.
NOTE:
Remove all fuses until all connections are made.
IMPORTANT!
If the vehicle is equipped with more than one battery wire at the ignition switch,
connect the RED wire from the 4 pin harness and the RED wire from the 6 pin
harness to separate vehicle battery wires.
2
ORANGE
ACCESSORY 1 ( + )
Locate the vehicle’s accessory wire at the ignition switch.
Verification:
This wire registers voltage when the key is turned to ACC
(Accessory) and the ON (or RUN) position. The voltage drops out when the
key is turned to the START (or CRANK) position.
Connect the ORANGE wire to the vehicle’s accessory wire.
1
RED
BATTERY 12V ( + )
Provides a constant 500mA +12V output intended for use with the transponder
output wire for activating a transponder bypass interface during remote start.
2 Pin Transponder Bypass Harness
2
BLACK
TRANSPONDER OUTPUT ( - )
The transponder output wire provides a ( - ) 500mA output when the remote start
function is activated and remains until 4 seconds after the remote start is
shutdown.
Programmable output:
While RS is ON, During Start, Until IGN OFF.
