The plumbing diagram for the full electric head system can be found on page 30. Instructions for use
are below.
To operate the head, first, make sure that the intake/fill
valve located below the through-hole in the floor of the
starboard console is open. The valve is open when its
handle is pointing straight up. This will allow water to
enter the head upon flushing.
ELECTRIC HEAD OPERATION
Once
you’ve
finished using the head, press the flush button
labeled
“Elec
Head”
on the switch panel. This will push the
contents of the head into the holding tank. Note that the
toilet contents will always go into the holding tank first, no
matter if planning on pumping out or using the macerator.
To evacuate the holding tank via a marine pump out, make sure that the handle for the Y-valve
(located on the front bulkhead of the deck hatch that is located in between the two consoles) is in
the correct position. This will allow the tank contents to be sucked out of the tank via the waste
deck fitting on the deck. The discharge for the deck fitting will always be the top most outlet on
the Y-valve. The handle is in the correct position if the arrow for the top outlet is NOT covered by
the wide end of the handle.
This is the position the handle should be kept in at all times to prevent the possibility of
mistakenly discharging waste overboard in waters illegally. (within 3 miles of shore and where
otherwise designated.) If desired the handle can be locked in this position by inserting a padlock
through the hole on the handle and through the housing on the Y-valve.