COBHAM Sea Tel 4010W-91, Installation Manual

Page: 46 / 141

4010W-91 Installation Manual Setup – Band Selection
7-2
7.4. Cross-Pol only Quad-Band LNB
This is the default setting for the Series 09 antenna pedestals with Quad-Band SMW LNB.
Use the Band1 when you want Cross-Pol Band1 output to be routed to below decks, Band 2 selects Cross-Pol Band2,
Band 3 selects Cross-Pol Band3 and Band 4 selects Cross-Pol Band4.
TRACK DISP
Setting Displayed band
selection ADE Band Select Parameters
(Tone, Voltage & Aux Status)
0170 Band1
Band2
Band3
Band4 Tone OFF, Volt 13, Aux 0
Tone ON, Volt 13, Aux 0
Tone OFF, Volt 18, Aux 0
Tone ON, Volt 18, Aux 0
7.1. Cross-Pol AND Co-Pol Single-Band LNBs
Use Xp 18 when you want Cross-Pol output to be routed to below decks and use Cp 18 when Co-Pol output is desired
below decks (
use the 18VDC settings to minimize current drawn by the LNBs ).
TRACK DISP
Setting
Displayed band
selection
ADE Band Select Parameters
(Tone, Voltage & Aux Status)
0040 Xp 13
Xp 18
Cp 13
Cp 18 Tone OFF, Volt 13, Aux 0
Tone OFF, Volt 18, Aux 0
Tone OFF, Volt 13, Aux 1
Tone OFF, Volt 18, Aux 1
7.2. Cross-Pol AND Co-Pol Dual-Band LNBs
Use Xp 13 when you want Cross-Pol low band output to be routed to below decks, Xp 18 selects Cross-Pol high band,
Cp13 selects Co-Pol low band and Cp 18 selects Co-Pol high band.
TRACK DISP
Setting Displayed band
selection ADE Band Select Parameters
(Tone, Voltage & Aux Status)
0040 Xp 13
Xp 18
Cp 13
Cp 18 Tone OFF, Volt 13, Aux 0
Tone OFF, Volt 18, Aux 0
Tone OFF, Volt 13, Aux 1
Tone OFF, Volt 18, Aux 1