COBHAM Sea Tel 4010W-91, Installation Manual

Page: 40 / 141

4010W-91 Installation Manual Basic Setup of the ACU
4-2
AZ LIMIT 1 0
Setup – Blockage & RF Radiation Hazard Zones
AZ LIMIT 2 0
EL LIMIT 12 90
AZ LIMIT 3 0
AZ LIMIT 4 0
EL LIMIT 34 90
AZ LIMIT 5 0
AZ LIMIT 6 0
EL LIMIT 56 90
5v OFFSET 0 Leave at factory Defaults
5V SCALE 0 Leave at factory Defaults
TX POLARITY 2 (Horizontal TX) Setup – Optimizing Polarity
& Cross Pol Isolation
TRACK DISP 130 or 170 Setup – Band Selection
* This setting is for the i-Direct 5000 Series modem to provide Modem Lock input &
Modem TX Mute functions. Refer to Setup – Modem Connect, Setup and Test for
values for some other common Satellite Modems and other SYSTEM TYPE parameter
information.
REMOTE PARAMETER 4010 5010 Optimize using Lesson
MK2 PCU Configuration Number N0xxx 076 077 Leave at factory Defaults
Home Flag Offset N6xxx 000 Setup – Home Flag Offset
DishScan Phase/Gain N7xxx 26 25 Leave at factory Defaults
4.4. SAVE NEW PARAMETERS
Parameters that have been changed are only temporarily changed until they are SAVED. If changes are made and not
stored, they will still be effective but will be lost when power is removed or the RESET key is pressed. Simultaneously
press, and quickly release the LEFT & RIGHT arrow keys to access “SAVE NEW PARAMETERS” directly from any other
menu display. Verify that the change(s) you have made is/are correct and then select “SAVE NEW PARAMETERS”.
Press UP arrow and then ENTER to save any recent changes into the ACUs NVRAM for permanent storage.