CMF Power Select, Installation And Operation Instructions Manual, Page: 7 / 40

Installation / Operation Instructions
CMF Power Select Ver. 3.0
REV 6.3
6
2.3.14 Remove the cover from the main electrical panel and locate the motor contactor
on the topmost terminal strip on the left side. In the center of the motor contactor
is a blue manual override switch. Slide this manual override to the left to engage
the contactor. (Fig 2) As long as this override is held, the hydraulic pump will run,
supplying hydraulic pressure to the system. With the pump running, use the
solenoid valve override controls to move the inner spout as outlined in the
previous section.
Be sure that the inner spout is all the way UP before
rotating.
Fig. 2: Motor Contactor
2.3.15 With the lift cylinder retracted (down position), check the position of the down
proximity sensor. If needed, adjust the down proximity sensor block to a point
where the LED light on the sensor comes on and the block completely covers the
face of the sensor with a maximum 1/16” gap between the sensor and the block.
(Fig. 3)
Note: Intrinsically safe sensors are opposite meaning the light will come
on when the sensor leaves the block, and the light will go off when the sensor is
in front of the block.
Fig. 3: Proximity Sensors
2.3.16 Jog the Power Select (UP) until the lift cylinder is fully extended (up position),
check the up proximity sensor as outlined above.