- 29 -
(20) IGNITION COIL
When mounting the ignition coil, insert a
thickness gauge between the ignition coil
and the flywheel to check the air gap .
(19) FLYWHEEL, COOLING BLOWER
and STARTING PULLEY
NOTE: When mounting the flywheel, be sure to
wipe off any oil on the tapered portion
of the crankshaft and flywheel .
a) Mount the flywheel on the crankshaft .
b) Install cooling blower and starting pulley to
the crankshaft .
c) Tighten crankshaft nut with a strap wrench
adopted as shown in the illustration .
COOLING
BLOWER
WASHER
Fig .3-50
Fig .3-51
Fig .3-52
Fig .3-53
STRAP WRENCH
IGNITION COIL
THICKNESS
GAUGE
M6 x 8 BOLT : 1 pc.
WIRE 1
CLAMP
NOTCH
M18 Nut : 1 pc . (24mm box wrench)
M6 × 25 mm bolt and washer : 2 pcs .
Make sure to put in the wire 1 to the notch on
the crankcase, and tighten it with the clamp .
(M6×8 mm bolt : 1 pc .)
Tightening torque
100 .0 - 120 .0 N
・
m
(1000 - 1200 kgf
・
cm)
(72 .3 - 86 .8 ft
・
lb .)
Tightening torque
7 .0 - 9 .0 N
・
m
(70 - 90 kgf
・
cm)
(5 .1 - 6 .5 ft
・
lb .)
Air gap
0.3 - 0.5 mm
(0.012 - 0.020 in.)
