- 10 -
FLYWHEEL
M6 x 25 BOLT and
WASHER : 2 pcs.
M6 x 8 BOLT : 1 pc.
CLAMP
COOLING BLOWER
M18 NUT : 1 pc.
WIRE : 1 pc.
IGNITION COIL
WASHER
STEP 5
STEP 6
STEP 7
Fig .3-5
Step
Parts to remove
Remarks and procedures
Fasteners
5
Ignition coil
Remove the spark plug cap from the spark plug and
remove the ignition coil from the crankcase .
10 mm box spanner
M6 x 25 mm
：
2 pcs .
6
Washer
Cooling Blower
Remove the starting pulley and cooling Blower from the
flywheel .Fit a box wrench or a socket wrench on the
flywheel nut and loosen the nut by knocking the wrench
sharply with a hammer . (See Fig . 3-6)
NOTE:
1 . Do not insert a screwdriver or other object between the
flywheel blades which is a synthetic resin, otherwise the
risk of damaging the blades might be occurred .
2 . Knock the wrench with a hammer in a counter clockwise
direction .
24 mm box spanner or
socket wrench
M18 nut
7
Flywheel
Remove the flywheel from the crankshaft . Leave the nut
temporarily to prevent the flywheel from dropping out . Fit
the flywheel puller as shown in Figure 3-7 and remove
the flywheel from the crankshaft by rotating the bolt at the
center in a clockwise direction .
(Knock the center bolt with a hammer sometimes)
Flywheel puller
Fig .3-6
Fig .3-7
FLYWHEEL PULLER
ATTACH NUT
TEMPORARILY
