STEERING AND FRONT SUSPENSION
Rack and Pinion
Page 7-12
2012 Turf/Carryall Vehicle Maintenance and Service Manual
7
7. Install the internal snap ring (11)
(Figure 7-8, Page 7-9)
.
8. Using a socket to apply pressure evenly, press in a new dust seal
(Figure 7-12, Page 7-12).
9. Apply a small amount of grease to the rack guide (13) where it comes into contact with the rack (17)
(Figure 7-8, Page 7-9)
.
10. Place a few drops of Loctite
®
222 to the threads of the screw (16)
(Figure 7-8, Page 7-9)
.
11. Install the rack guide (13), pressure spring (14), and screw (16). The screw should be threaded in until
a rotational torque of 10 in-lb (1.13 N·m) is achieved
(Figure 7-8, Page 7-9)
.
11.1. Reposition the rack and pinion in a vise.
11.2. Insert a 3/8-inch deep well socket into the steering column end of the universal joint (2) and tighten
the bolt (1) to 15 ft-lb (20.3 N·m)
(Figure 7-14, Page 7-12)
.
11.3. Use a torque wrench connected to the 3/8-inch deep well socket to measure the resistance of the
rack and pinion. Rotational resistance should measure 7 to 15 in-lb (0.8 to 1.7 N·m).
11.4. If measured resistance does not equal 7 to 15 in-lb, loosen the lock nut (15) and tighten the screw
(16) until it bottoms out, then back the screw off one quarter turn. Tighten the lock nut to 28 ft-lb (38
N·m)
(Figure 7-13, Page 7-12)
.
See following NOTE.
Figure 7-12 Press In Dust Seal
Figure 7-13 Rack and Pinion Adjustment
Figure 7-14 Rack and Pinion Resistance
DUST SEAL
15/16-INCH DEEP
WELL SOCKET
16
15
1
2
25
VISE
3/8-INCH
1/4 DRIVE
DEEP WELL
SOCKET
Summary of Contents for Carryall 2 Plus
