![background image](http://html1.mh-extra.com/html/club-car/carryall-2-plus/carryall-2-plus_service-manual_2626705107.webp)
STEERING AND FRONT SUSPENSION
Front Suspension Components
2012 Turf/Carryall Vehicle Maintenance and Service Manual
Page 7-23
7
KINGPIN AND STEERING SPINDLE INSTALLATION
1. Inspect all parts and replace them as necessary.
2. Install the kingpin (26) over the leaf spring eye. Insert the bolt (25) and install the nut (14)
(Figure 7-21,
Page 7-20 or Figure 7-23, Page 7-22)
. Tighten the nut to 23 ft-lb (31 N·m).
3. Install the wave washer (20) and steering spindle on the kingpin.
4. Install the steering spindle on the kingpin.
5. Install the thrust washer (38), hardened flat washer (37), upper plate clevis (16), conical washer (36), and
nut (35). Tighten the nut to 63 ft-lb (83 N·m).
6. Install tie rod ball joints and drag link into spindles.
See Tie Rod and Drag Link on page 7-14.
7.
Vehicles with four-wheel brakes:
Connect the front brake cables on four-wheel brake vehicle
in reverse
order of disassembly
(Figure 7-19, Page 7-18)
.
8.
Vehicles with two-wheel brakes:
Install front hub and wheel.
See Front Wheel Bearings and Hub
Installation on page 7-25.
DELTA A-PLATE REMOVAL
1. Loosen lug nuts on both front wheels and raise front of the vehicle with a chain hoist or floor jack. Place
jack stands under the front cross tube of the vehicle frame and lower the vehicle onto the jack stands.
2. Remove wheel. Remove bolts (10 and 24), A-Plate straps (14), and nuts (5)
(Figure 7-20, Page 7-19 or
Figure 7-22, Page 7-21)
.
3. Remove the lower shock absorber mounting nut (9), then slide the shock absorber free of the Delta A-
Plate.
4. Remove the Delta A-Plate (1).
5. Inspect the bushings (2) and sleeves (3 and 4) in the Delta A-Plate and replace them if necessary.
DELTA A-PLATE INSTALLATION
1. Install the A-Plate in reverse order of removal. Tighten the A-Plate suspension bolts (10 and 24) to 20
ft-lb (27 N·m)
(Figure 7-20, Page 7-19 or Figure 7-22, Page 7-21)
.
2. Install the wheels and adjust the wheel alignment.
See Wheel Alignment on page 7-15.
SHOCK ABSORBER REMOVAL
1. Inspect the shock absorbers for fluid leakage at the point where the shaft enters the shock absorber
body. Leaking shock absorbers should be replaced.
2. Remove the nut (9) attaching the shock absorber to the A-Plate
(Figure 7-20, Page 7-19 or Figure 7-22,
Page 7-21)
.
3. Remove the nut (32) and bolt (8) attaching the shock absorber to the shock and gear support.
4. Remove the shock absorber.
Summary of Contents for Carryall 2 Plus
