USER MANUAL :
DOCUMENT NAME
To switch between the Diagnostic Mode and Command Mode, simply press
from the Diagnostic Mode to Command Mode can take several seconds depending on what the
executing. Command Mode is shown with the [COMMAND MODE] text in the communications block.
responses will be displayed in the 'Communications' blo
selecting the 'Clear Screen' option.
The logger must be in 'Command Mode' before any of the settings changes or other instructions are accepted
command in Diagnostic Mode will cause the
The information on this screen is ordered in various groups. The 'General Details' box holds information that is not alterabl
and is general information about the logger. This information consists of the following data:
Information
Device Code
Firmware Version
Serial Number
Latitude
Longitude
Signal Strength
Local IP
Datalog Size
The Device Code assigned to this particular
addressing this code. This code is unique to all
manufacture.
Firmware version of the software loaded on the
Serial number of this
Current logger latitude
Current logger longitude
Signal strength of the last
Local IP address assigned by the GSM network. This data is important when using a static
IP system to ensure that the correct IP has been assigned to the
Number of records in the datalog/maximum numb
type.
MANUAL : CDS541 CUMULUS PULSE LOGGER
NAME
CLASSIFICATION
DATE
PAGE
To switch between the Diagnostic Mode and Command Mode, simply press the 'Command/Connect' button. Switching
stic Mode to Command Mode can take several seconds depending on what the
executing. Command Mode is shown with the [COMMAND MODE] text in the communications block.
responses will be displayed in the 'Communications' block. This information can be cleared by right clicking in this box and
before any of the settings changes or other instructions are accepted
command in Diagnostic Mode will cause the logger to switch to Command Mode but that last instruction will
The information on this screen is ordered in various groups. The 'General Details' box holds information that is not alterabl
. This information consists of the following data:
Notes
The Device Code assigned to this particular logger. All communications are initiated by
addressing this code. This code is unique to all loggers and is assigned at the time of
Firmware version of the software loaded on the logger
Serial number of this logger - assigned in the factory.
logger latitude - read if the GPS is on.
logger longitude - read if the GPS is on.
Signal strength of the last GSM communications, expressed as a percentage.
Local IP address assigned by the GSM network. This data is important when using a static
IP system to ensure that the correct IP has been assigned to the logger.
umber of records in the datalog/maximum number possible for the selected application
PAGE
'Command/Connect' button. Switching
stic Mode to Command Mode can take several seconds depending on what the logger is currently
executing. Command Mode is shown with the [COMMAND MODE] text in the communications block. All commands and
ck. This information can be cleared by right clicking in this box and
before any of the settings changes or other instructions are accepted
. Sending a
to switch to Command Mode but that last instruction will fail.
The information on this screen is ordered in various groups. The 'General Details' box holds information that is not alterable
. All communications are initiated by
s and is assigned at the time of
GSM communications, expressed as a percentage.
Local IP address assigned by the GSM network. This data is important when using a static
er possible for the selected application
