31
3.3.4 Job continuation
The job continuation is available for welding power sources with a soft-
ware version of X.09 or higher.
The job continuation can be applied in the 4-cycle and Super-4-cycle
operating modes. If job continuation is active in Super 4-cycle, this has
priority over the "Step modulation" function.
Up to a maximum of 10 jobs can be toggled with the torch button of
any of the manual welding torches. Press and hold the torch button for
approximately 0,5 seconds to release a job continuation.
The start job must be in the first position of any ten position, for example:
storage space 11, 21, 31 … 801. As soon as an empty storage space is
available between an active job and the next job, this is detected and the
system will jump back to the job with the position xx1.
Example:
active job: 44, next job: 48, job continuation to storage space: 41.
3.4 Compensation of the external welding circuit
3.4.1 For software version x.05 or higher
The compensation is done by the entry of the cable lengths (m). Factory
setting is 13 m.
Function
Description
Cable length
Add the cable lengths of the cable assemblies
connected to the welding power source and enter the
value as a number by turning the rotary knob. The
corrections are maintained after switching off the
welding power source.
Tau (time
constant)
If there is a great distance between the cable assembly
and the minus return line, an inductive influence
develops. This has an influence on the characteristic
curve.
A compensation is made by means of the parameter
"Tau". By increasing the parameter (+0,05 … +0,1) a
large area can be compensated.
An optimum compensation of the external welding
current circuit has been reached if – in the case
of correct weld parameters – the fine adjustment
(ArcLength) and dynamics (ArcDynamic) is on "- 0 -".
NOTICE!
