M02
J40
M6-
04
WDAT-3
2.160-3.660
- R E C E P T I O N -
20
- R E C E P T I O N -
INSPECTION UPON RECEPTION
Check on arrival that the unit has not suffered damage during transit and that it is complete in every part as specified in
the order. In the event of visible damage/deficiencies being discovered, make a note immediately on the delivery
document with the comment: "CONDITIONAL ACCEPTANCE — CLEAR EVIDENCE OF DEFICIENCIES/DAMAGE
DURING TRANSIT", then inform both the supplier and the carrier of the details by fax and by registered mail with advice
of receipt not later than 8 days after taking consignment. Notifications sent after 8 days have elapsed will be ignored.
STORAGE
Shelter from: direct sunlight, rain, sand and wind
Temperature: maximum 60°C minimum -10°C
Maximum humidity: 90%
The respect of the instructions on the exterior side of the packaging assures the physical and functional integrity of the
unit for the final user’s advantage.
It is recommended to:
•
Handle
carefully
•
Keep in a dry place
•
Avoid putting other objects on top of the unit (respect the limits of levels of superimposition shown in the
package)
•
Avoid placing the unit with thermoretractable protection under the sun since the pressure of the circuits can
assume values which activate the safety valves.
HANDLING
The operation of handling the unit must be carried out respecting the instructions of the safety norms in force (Legislative
Decree 626/94 and following modifications)
Before starting the handling operations:
•
Verify that the lifting capacity of the means used is adequate to the unit weight
•
Consider that the barycentre could be moved with respect to the center of the unit
•
Before starting to lift, verify that the unit is at a stable balance
The following examples are indications; the choice of the means and of the handling modes will depend on factors, such
as:
The unit weight
•
Type and overall dimensions of the unit
•
Place and route for the handling (dirt yard, asphalted square, etc. )
•
Condition of the place of destination (roof, square, etc.)
•
Distances, drops and gradients.
labels / yellow brackets show the lifting points
use a spacer bar to avoid damaging the unit
2 lifting points
use 2-boom tie rods
(2 cables/chains/straps for each unit side)
according to the unit type, holes and/or lifting
brackets are positioned in different points
Summary of Contents for WDAT-3 2.160
Page 2: ......
