HCS QUAD PEDESTAL KIT INSTALLATION GUIDE
ClipperCreek
,
Inc.
Page 11
3. Mounting the Pedestal Post
Once the concrete pad with anchor bolts has been
prepared and the service conductors have been pulled
through the underground conduit, the pedestal post
may be placed.
NOTE:
EVSEs will be on the same side(s) as
the Wire Access Holes; orient the Pedestal Base
accordingly.
NOTE:
DO NOT REMOVE THE TAPE
at the
bottom of the pedestal. This tape is provided for finish
and weather protection of the pedestal post.
• Feed all service conductors up through the inside
of the pedestal post. The conductors must be of
sufficient length to pass beyond the top of the
pedestal so that final connections can be worked
with comfortably at a later step.
• Align the pedestal post base notches with the four
anchor bolts and ease it into place.
• Nuts and washers may be used under the pedestal
base to adjust the vertical alignment of the
pedestal should the concrete pad not be level.
Figure 6: Pedestal Post Mounting by Pattern
Wire Access Hole
Wire Access
Hole
Service
conductors
are pulled
beyond top of
the pedestal.
Five (5) feet is
adequate.
Configurations
may vary
slightly from
what is depicted
in this manual.
DO NOT REMOVE
PROTECTIVE TAPE
4. Install the Pedestal Base Cover
A two-piece pedestal base cover set is included in the
pedestal kit. The purpose of the pedestal base cover is
to beautify the installation and to protect against injury
from protruding anchor bolts.
• The two covers are of an identical overlapping
design.
• Slide one cover on the front side of the pedestal
base until the center notch surrounds half of the
pedestal post. Slide the other cover onto the rear
side in the same manner. Ensure that the flanges
of each cover piece are tucked inside of the
opposite cover.
• Align the four screw holes of each cover piece
with the corresponding screw holes on the
opposite cover.
• Secure each cover piece to the other with four (4)
#6-32 x 3/8” flat-head tapered screws using a #2
Philips-head screwdriver.
Figure 7: The Pedestal Base Covers
DO NOT REMOVE
PROTECTIVE
TAPE
INITIAL PEDESTAL INSTALLATION (continued)
