Clipper Jumbo 1000 P13, Operating Instructions Manual

Page: 17 / 24

17
6 Maintenance and servicing
6.1 Maintenance of the machine
To ensure a long-term quality from the cutting with the Jumbo 1000 P13, please follow the
maintenance plan below:
B
e
g
in
o
f
th
e
d
a
y
D
u
ri
n
g
t
h
e
c
h
a
n
g
in
g
o
f
th
e
t
o
o
l
E
n
d
o
f
th
e
d
a
y
E
v
e
ry
w
e
e
k
A
ft
e
r
a
f
a
u
lt
A
ft
e
r
a
d
a
m
a
g
e
Visual control (general aspect,
water tightness)
Whole machine
Clean
Flange and blade fixing devices Clean
Belts tension Check tension and adjust
Water pan Clean
Water pump Clean
Water hoses and nozzles Clean
Water pump filter Clean
Head guiding bars Clean
Motor housing Clean
Reachable nuts and screws Tighten up
Maintenance of the motor
Always perform the maintenance with the motor switched off.
Adjustment and replacement of the belts
To adjust the belts, firstly remove the belt guard by unscrewing the 6 nuts. Loosen the 4 motor bolts
and shift the motor by using the two screws on the side.
To replace the belts, move the motor completely forward. Adjust the belts and retighten them by
shifting the motor to the left.
Always use a matched set of belts. Do not replace single belts.
Lubrication
The Jumbo 1000 P13 uses life-lubricated bearings. Therefore, you don’t need to lubricate the
machine at all.
Cleaning of the machine
Your machine will last longer if you clean it thoroughly after each day of work, especially water
pump, water pan, motor, blade flange and cutting head rails.