12
3.2 Starting the machine
Make sure that the blade does not touch the cutting table when you start the engine.
Turn the fuel valve to the ON position.
Move the choke lever to the CLOSED position.
NOTE: do not use the choke if the engine is
warm or the air temperature is high.
Move the throttle control lever slightly to the
left.
Put the engine switch on ON, and make sure
the emergency switch on the board of the
machine is in the correct position.
Pull the starter grip lightly until you feel
resistance, then pull briskly.
CAUTION: Do not allow the starter grip to
snap back against the engine. Return it gently
to prevent damage to the starter.
As the engine warms up, gradually move the
choke lever to the OPEN position.
Position the throttle control lever for the
maximum engine speed.
To stop the engine, move the throttle control lever fully to the right, then turn the engine switch to
the OFF position. Turn the fuel valve to the OFF position.
Summary of Contents for Jumbo 1000 P13
Page 1: ...Jumbo 1000 P13 OPERATING INSTRUCTIONS ...
Page 2: ...2 ...
Page 4: ...4 ...
Page 23: ...23 ...
