Climax VST-2752, User Manual, Page: 54 / 55

51

137 – Panel Tamper

When the Control Panel tamper switch
is triggered.

139 – Verification / Alarm Confirmation

147 – Sensor Supervisor Failure

When the Control Panel fails to
receive the signal transmitted from any
one of the devices individually for a
preset period.

151 – Gas

154 – Water leakage

When a Water Sensor or Door Contact
set as Wate r is triggered.

158 – High Temperature

When the temperature exceeds High
Temperature setting.

159 – Low Temperature

When the temperature drops below
Low Temperature setting.

162 – CO detector

301 – AC Failure

When the AC power fails for more than
10 sec.

302 – Low Battery

When the battery voltage of the Panel
and any one of the devices is low.

311 – Panel Battery Missing/Dead

When the Control Panel Battery is
missing or disconnected.

344 – Interference

374 – Arm with Fault

When fault exists in system, and the
system is armed by confirming the arm
action. (Arm Fault Type set to Confirm.)

380 – Device AC Failure

When an AC power accessory device
loses the AC power connection.

383 – Device Tamper

When a device’s tamper switch is
triggered.

384 – Device Low Battery

When a device’s is under low battery.

389 – Self Test Failure

400 – Arm/Disarm (by Remote Controller)

When the system is armed or
disarmed by using the Remote
Controller.

401 – Arm/Disarm by Panel

When the system is armed or
disarmed by entering the PIN code.

408 – Set/Unset Disarm

407 – Disarm/Away Arm/Home Arm by
Remote Keypad

465 – Alarm Reset

570 – Zone Bypass

When fault exists in system, and the
system is armed by ignoring the fault
event. (Arm Fault Type set to Direct
Arm)

602 – Periodic test report

When Control Panel makes periodic
Check-in reporting.

606 - Follow-On Function

When Control Panel reports to CMS to
request opening Listen-in function.