2
abnormal > SIM card missing > No
signal/reception > SIM card PIN code
error.
11. DC Jack
—
DC
12V
1A
switching
power
connection
12. Power Switch
13. Local Programming Telephone Unit
Input / PC Programming Telephone
Jack
—
A special telephone cord is provided
to connect CTC-1052-QT and your
phone unit for Local Programming
(optional).
—
A PC programming cable (QT Cable
C) is provided to connect CTC-1052-
QT and your computer for PC
Programming (optional).
BACK VIEW
14. Mounting Holes
15. Mounting Bracket
1.2. The Power Supply
An AC power adapter is required to connect
to a wall outlet. Be sure only to use an
adapter with the appropriate AC voltage
rating to prevent component damage. A DC
12V output and 1A switching power is
generally used to power CTC-1052-QT.
In addition to the adapter, there is a
rechargeable battery inside CTC-1052-QT,
which serves as a back-up in case of a
power failure.
During normal operation, the AC power
adapter is used to supply power to CTC-
1052-QT and at the same time recharge
the battery. It takes approximately 72 hours
to fully charge the battery.
After power is supplied to CTC-1052-QT,
slide the power switch to ON position to
power on the Control Panel.
1.3. Insert 4G/LTE SIM Card
CTC-1052-QT Panel features built-in 4G/LTE
communication facility to report to the
Monitoring Station.
To Insert SIM card:
<NOTE>
It is recommended to disable the SIM
card PIN code before inserting into the
Control Panel.
The 4G/LTE SIM card base is located on the
rear side of the unit:
Insert the SIM card with the chip side facing
up.
Push to the furthest extend, then press on
the edge of the SIM card firmly to secure it.
SIM Card will delete its SMS message
whenever the CTC-1052-QT is powered on.
To remove SIM card:
